Anonymous
Apr 20, 2026
Rating: 5/5
Excellent stability
Temperature consistency is much better than the aluminum block. Highly recommended for engineering filaments.
Description
Reviews
| Brand | - |
| Category | 3D Printing Accessories / Hot End and Nozzle |
| Origin | - |
| Voltage | 24V |
| Power Rating | 40W |
| Material | Ceramic |
| Max Temperature | 300°C |
| Compatibility | E3D Revo System |
| Heater Thread | M6 |
| Weight | 18g |
| Wire Length | 1000mm |
| Thermistor Type | 100K NTC |
| Package Contents | Heating Block, Cartridge, Thermistor |
Anonymous
Apr 20, 2026
Rating: 5/5
Excellent stability
Temperature consistency is much better than the aluminum block. Highly recommended for engineering filaments.
Anonymous
Mar 25, 2026
Rating: 4/5
Easy install
Swapped it out in 10 minutes. Works great right out of the box.
Anonymous
Mar 25, 2026
Rating: 5/5
Must have upgrade
If you run a Revo system, this is the way to go. No more heat creep issues.
Anonymous
Feb 27, 2026
Rating: 5/5
Durable ceramic
Feels very solid. No issues after 500 hours of printing with ABS and ASA.
Anonymous
Feb 02, 2026
Rating: 4/5
Good but pricey
Works well for high temp filaments. A bit expensive though but worth the reliability.
Q: Does this work with 12V printers?
A: No, this kit is rated for 24V systems only. Using 12V will result in insufficient heating.
Q: What tools are needed for installation?
A: You will need a hex key and a nozzle wrench to swap the hotend components.
Q: Can I print polycarbonate with this?
A: Yes, the 300°C limit supports most polycarbonate filaments safely.
Q: Is this genuine E3D?
A: Yes, this is an official E3D genuine part with full warranty support.
Q: Is the thermistor included?
A: Yes, the kit comes complete with heater cartridge and thermistor pre-installed.