Anonymous
Mar 17, 2026
Rating: 4/5
Good board, missing schematic
The hardware works perfectly but I wish there was a downloadable schematic included in the package for custom modifications.
Description
Reviews
| Brand | - |
| Category | Electronic Components / Maker DIY / Development Boards & Control Boards |
| Origin | - |
| Microcontroller Model | STM32F103ZET6 |
| CPU Architecture | ARM Cortex-M3 |
| Maximum Frequency | 72 MHz |
| Flash Memory | 512 KB |
| SRAM Capacity | 64 KB |
| GPIO Pins | 112 Fast I/O Ports |
| Operating Voltage | 3.3V |
| Input Power Supply | 5V via USB or Pin |
| Debug Interface | JTAG / SWD |
| Board Dimensions | 55 x 55 mm |
Anonymous
Mar 17, 2026
Rating: 4/5
Good board, missing schematic
The hardware works perfectly but I wish there was a downloadable schematic included in the package for custom modifications.
Anonymous
Feb 28, 2026
Rating: 5/5
Great for beginners
Easy to set up with Keil MDK. The pinout is clearly labeled which helped me a lot during my first embedded project.
Anonymous
Feb 19, 2026
Rating: 5/5
Excellent build quality
Pins are labeled clearly and the PCB feels sturdy. I have used it for several weeks without any issues.
Anonymous
Feb 15, 2026
Rating: 5/5
Perfect for IoT projects
Low power consumption verified. I am using this for a sensor node and the battery life is impressive.
Anonymous
Jan 19, 2026
Rating: 5/5
Fast shipping
Works perfectly out of the box. Arrived earlier than expected and was well packaged.
Q: Can I power it with 9V?
A: No, the maximum recommended input voltage is 5V. Applying 9V directly may damage the voltage regulator.
Q: Are pin headers soldered?
A: Yes, all standard pin headers come pre-soldered for immediate use.
Q: Does this support Arduino IDE?
A: Yes, this board is compatible with the Arduino IDE via the STM32duino package.
Q: Is the chip pre-flashed?
A: It comes with a basic bootloader test firmware to verify hardware functionality before use.
Q: Is the debugger included?
A: No, the board does not include an on-board debugger. You will need a separate ST-Link programmer.