Anonymous
Apr 04, 2026
Rating: 3/5
Decent but needs tuning
Works okay but the documentation was a bit sparse. Had to find code examples online.
Description
Reviews
| Brand | - |
| Category | Electronic Components / Maker DIY / Computer Hardware, Monitors & Peripherals |
| Origin | - |
| Input Voltage | 3.3V - 5.5V DC |
| Output Signal | Analog Voltage (0-2.3V) |
| TDS Measurement Range | 0 - 1000 ppm |
| Operating Temperature | 0°C - 50°C |
| Probe Cable Length | Approximately 45cm |
| Interface Type | PH2.0-3Pin Connector |
| PCB Material | FR-4 Fiberglass |
| Accuracy | ±10% F.S. |
| Compatible Platforms | Arduino, Raspberry Pi, ESP32 |
| Package Weight | 25 grams |
Anonymous
Apr 04, 2026
Rating: 3/5
Decent but needs tuning
Works okay but the documentation was a bit sparse. Had to find code examples online.
Anonymous
Mar 23, 2026
Rating: 5/5
Essential for water projects
Verified purchase. Using it to monitor nutrient levels. Very satisfied.
Anonymous
Mar 01, 2026
Rating: 5/5
Perfect for Hydroponics Monitor
Works great with my ESP32 setup. Readings are consistent after calibration.
Anonymous
Feb 01, 2026
Rating: 4/5
Good value sensor
Does the job well. Just make sure you calibrate it with standard solution first.
Anonymous
Jan 19, 2026
Rating: 5/5
Reliable Analog Output
Clean signal, easy to read with ADC. No noise issues on my breadboard.
Q: Can this be used with 3.3V logic?
A: Yes, it operates within 3.3V to 5.5V range.
Q: Does it come with calibration powder?
A: No, calibration solutions are sold separately.
Q: Is the probe waterproof?
A: The probe is waterproof, but the module board itself is not.
Q: What is the response time?
A: Typically stabilizes within 30 seconds in stable water.
Q: Can it measure saltwater?
A: It measures conductivity, so yes, but high salinity may exceed range.